Get the latest Cisco CCDA 200-310 dumps and 200-310 pdf, pass exam certification

Work hard! It’s not hard to get certified! Share the latest Cisco CCDA 200-310 exam dump for free. online 200-310 exam practice tests. the latest 200-310 exam questions and answers, and guarantee your skills and exam experience! “Cisco Certified Design Associate Exam (CCDA)” – 200-310 exam! pass4itsure.com expert recommendation! Top pass rate!

exam success
image from: https://social.hays.com/2017/09/07/seven-things-achieve-career-success/

Get the latest Cisco CCDA 200-310 pdf

[PDF] Free Cisco 200-310 pdf dumps download from Google Drive: https://drive.google.com/open?id=1THEJw5oM0L4UQ80O_XbU2IpIPuC8a5W8

[PDF] Free Full Cisco pdf dumps download from Google Drive: https://drive.google.com/open?id=1xM4qOTLaMDVyi16Ta0wO8qvdS21TfgOU

Valid information provided by Cisco officials

200-310 desgn – Cisco: https://www.cisco.com/c/en/us/training-events/training-certifications/exams/current-list/200-310-desgn.html

The latest Cisco CCDA 200-310 exam practice questions test your strength

QUESTION 1
Traditionally, the DMZ exists between which two locations? (Choose two.)
A. Building distribution
B. Building access
C. Corporate network
D. Metro Access
E. Internet
Correct Answer: CE

QUESTION 2
Which three are features of LWAPP? (Choose three.)
A. firmware synchronization
B. local management of APs
C. configuration changes manually synced
D. encryption of control channel
E. configuration data only on the WLC
F. wireless control free operation
G. replaces 802.1x for authentication in wireless connections
Correct Answer: ADE

QUESTION 3
When designing the identity and access control portions for the enterprise campus network, which of these solutions
would be the most appropriate solution to consider?
A. 802.1X
B. ACLs in the core layer
C. Cisco Security MARS
D. NetFlow
Correct Answer: A

QUESTION 4pass4itsure 200-150 exam question q4

Refer to the exhibit. Where should routes in the routing table be aggregated or summarized?
A. in the distribution toward the access
B. in the distribution toward the core C. in the core toward the data center
D. in the core toward the distribution
Correct Answer: B

QUESTION 5
What describes the link performance?
A. Bandwidth
B. Utilization
C. Availability
Correct Answer: A
Explanation: https://en.wikipedia.org/wiki/Network_performance

QUESTION 6

pass4itsure 200-150 exam question q6

Refer to the exhibit.
The organization is migrating away from FHRP. VSS has been implemented on a pair of Cisco Catalyst 6500 Series
Switches. In order to avoid changes to end hosts, the default gateway is carried over to the SVI on the VSS. Why does
the
implementation plan require a four-hour wait after removing the FHRP configuration?
A. The VLAN interface MAC address and the FHRP MAC address are different. It takes four hours for the VLAN
interface to come up.
B. The SVI IP address and the FHRP IP address are different. It takes four hours for the SVI to come up.
C. The VLAN interface MAC address and the FHRP MAC address are different. It takes four hours for the ARP cache to
time out.
D. The VLAN interface IP address and the FHRP IP address are different. It takes four hours for the VLAN interface to
come up.
E. The VLAN interface IP address and the FHRP IP address are different. It takes four hours for the ARP cache to time
out.
Correct Answer: C

QUESTION 7
Which technology allows remote networks to be connected via site-to-site tunnels?
A. IPsec VPN
B. AnyConnect VPN
C. SSL VPN
D. EasyConnect VPN
Correct Answer: A

QUESTION 8
Cisco Unified Wireless networks support two campus design models: Centralized or Local Mode and Cisco
FlexConnect. Which statement about the Local Mode design model is true?
A. The wireless LAN controller and access points are co-located
B. It is recommended for remote-site deployments
C. It is recommended for sites that use less than 50 APs
D. It is recommended for sites with a local WAN distribution layer
Correct Answer: D

QUESTION 9
What are the three modes of unicast reverse path forwarding? (Choose three.)
A. strict
B. loose
C. VRF
D. global
E. PIM
F. local
Correct Answer: ABC

QUESTION 10
What are three valid BGP attributes? (Choose three.)
A. AS path
B. neighbor
C. next hop
D. bandwidth
E. origin
F. delay
Correct Answer: ACE

QUESTION 11pass4itsure 200-150 exam question q11

Refer to the exhibit. Which configuration can be used to implement FHRP protocol and load balancing at the same
time?
A. R1 Interface Ethernet0 ip address 171.16.6.5
255.255.255.0 standby 1 preempt
standby 1 ip 171.16.6.100
standby 1 track Serial0
standby 2 preempt
standby 2 ip 171.16.6.200
standby 2 track serial 0
standby 2 priority 95
!
!
R2
interface Ethernet0
ip address 171.16.6.6 255.255.255.0
standby 1 preempt
standby 1 ip 171.16.6.100
standby 1 track Serial0
standby 1 priority 95
standby 2 preempt
standby 2 ip 171.16.6.200
standby 2 track serial 0
B. R1 Interface Ethernet0 ip address 171.16.6.5
255.255.255.0 standby 1 preempt
standby 1 ip 171.16.6.100
standby 1 track Serial0
standby 1 priority 95
!
!
R2
interface Ethernet0
ip address 171.16.6.6
255.255.255.0 standby 1 preempt
standby 1 ip 171.16.6.100
standby 1 track Serial0
standby 1 priority 95
C. R1 Interface Ethernet0 ip address 171.16.6.5
255.255.255.0 standby 1 preempt
standby 1 ip 171.16.6.100 standby 1 track Serial0 standby 1 priority 95 standby 2 preempt
standby 2 ip 171.16.6.200 standby 2 track serial 0 standby 2 priority 95
!
!
R2
interface Ethernet0
ip address 171.16.6.6
255.255.255.0 standby 1 preempt
standby 1 ip 171.16.6.100 standby 1 track Serial0 standby 2 preempt
standby 2 ip 171.16.6.200 standby 2 track serial 0
D. R1 Interface Ethernet0 ip address 171.16.6.5
255.255.255.0 standby 1 preempt
standby 1 ip 171.16.6.100 standby 1 track Serial0 standby 1 priority 95
!
!
R2
interface Ethernet0
ip address 171.16.6.6
255.255.255.0 standby 1 preempt
standby 1 ip 171.16.6.100
Correct Answer: A

QUESTION 12
If a teleworker is required to access the branch office via a secure IPSEC VPN connection, which technology is
recommended to provide the underlying transport?
A. ISDN
B. Metro Ethernet
C. Frame Relay
D. ADSL
E. ATM
Correct Answer: D

QUESTION 13
In an EAP-enabled WLAN, which component sends the EAP identity request?
A. WLAN controller
B. ACS server
C. access point
D. wireless client
Correct Answer: A

Share Pass4itsure coupons for free

pass4itsure coupon

Reasons to choose Pass4itsure

Pass4itsure offers the latest exam practice questions and answers free of charge! Update all exam questions throughout the year,
with a number of professional exam experts! To make sure it works! Maximum pass rate, best value for money! Helps you pass the exam easily on your first attempt.

about pass4itsure

This maybe you’re interested

Summarize:

Collecting the latest and most effective Cisco CCDA 200-310 exam practice questions to help you improve exam success,
200-310 pdf and 200-310 video learning make it easier to gain knowledge! Full 200-310 exam dump: Experts recommend real leader Pass4itsure. Click here to easily pass the 200-310